Safety devices on table-top units

The following illustration shows a size 6.10 electric combi oven as representative of all table-top units:

Item	Protective device	Function	Check
1	Cover can only be removed using tool	Prevents live parts from being touched accidentally Prevents access to the moving fan from the wiring compartment	Check that the cover is in place
2	Operating panel can only be removed using a tool	Prevents live parts from being touched accidentally	Ensure that the operating panel is in place
3	Appliance door	Protects the user and outside environment from hot steam	Check the door pane regularly for scratches, cracks, indentations etc. and replace it if any are found
4	Suction panel in cooking chamber; can only be removed using a tool	Prevents access to the moving fan and ensures good heat distribution	See 'Releasing and securing the suction panel' in the user manual
5 (no picture)	Safety thermostat Boiler Cooking chamber	Switches off the appliance if temperature too high	An error code is output in the event of a fault (Please contact an authorized service company to reset the safety thermostat)
6 (installed by customer)	Disconnector	Used to disconnect the appliance from the power supply during work on the appliance and in case of a hazardous situation	There is no need for operating personnel to perform a test
7 (installed by customer)	Gas shut-off device	Used to disconnect the appliance from the gas supply during work on the appliance and in case of a hazardous situation	There is no need for operating personnel to perform a test

The following measures increase the safety additionally:

Measure	Function	Check
Magnetic switch for appliance door (electric door sensor)	When the appliance door is opened, the switch stops: rotation of the fan wheel (comes to a stop after a few seconds) operation of the heating element Distribution of the cleaning agents by the fully automatic oven cleaning system Prompt to close the appliance door	Check magnetic door switch at low temperature Action: Open the appliance door fully Press Start Result: Motor must not start up.
Appliance door handle with venting position	Prevents scalding of user's face and hands from escaping steam	Check door positions at low temperature
Restart after power failure in case cleaning agent was left in the appliance	Restarts fully automatic and semi-automatic oven cleaning in a defined state after a power failure	None

Measure

Function

Check

Magnetic switch for appliance door (electric door sensor)

When the appliance door is opened, the switch stops:
- rotation of the fan wheel (comes to a stop after a few seconds)
- operation of the heating element
- Distribution of the cleaning agents by the fully automatic oven cleaning system

Check magnetic door switch at low temperature

Action:

Result:

Motor must not start up.

Appliance door handle with venting position

Check door positions at low temperature

Restart after power failure in case cleaning agent was left in the appliance

Restarts fully automatic and semi-automatic oven cleaning in a defined state after a power failure

None