1

Cover can only be removed using tool

• Prevents live parts from being touched accidentally

• Prevents access to the moving fan from the wiring compartment

Check that the cover is in place

2

Operating panel can only be removed using a tool

Prevents live parts from being touched accidentally

Ensure that the operating panel is in place

3

Appliance door

Protects the user and outside environment from hot steam

Check the door pane regularly for scratches, cracks, indentations etc. and replace it if any are found

4

Suction panel in cooking chamber; can only be removed using a tool

Prevents access to the moving fan wheel(s) and ensures good heat distribution

See 'Releasing and securing the suction panel' in the user manual

5

Built-in preheat bridge in appliance door

Prevents scalding from escaping steam when the loading trolley is not in the appliance during preheating

None

6

(no picture)

Safety thermostat

• Boiler

• Cooking chamber

Switches off the appliance if temperature too high

An error code is output in the event of a fault

(Please contact an authorized service company to reset the safety thermostat)

7

(installed by customer)

Disconnector

Used to disconnect the appliance from the power supply during cleaning, repair and servicing work and in a hazardous situation

There is no need for operating personnel to perform a test.

8

(installed by customer)

Gas shut-off device

Used to disconnect the appliance from the gas supply during cleaning, repair and servicing work and in a hazardous situation

There is no need for operating personnel to perform a test.

Magnetic switch for appliance door (electric door sensor)

• When the appliance door is opened, the switch stops:
  • rotation of the fan wheel (comes to a stop after a few seconds)
  • operation of the heating element
  • Distribution of the cleaning agents by the fully automatic oven cleaning system

• Prompt to close the appliance door

Check magnetic door switch at low temperature

Action:

• Open the appliance door fully

• Press Start

Result:

Motor must not start up.

Restart after power failure in case cleaning agent was left in the appliance

• Restarts fully automatic and semi-automatic oven cleaning in a defined state after a power failure

None